Plug the two probes into the multimeter and set the dial to 'continuity. ' If you place the red and black probes on either side of the part (some parts have diodes and are one-directional so you need to arrange the probes accordingly), and you get a read of approximately zero, electricity can flow through the part
2 votes Thanks 1
snagisa532
is that right I've been looking for an answer for a while :)
Answers & Comments
Answer:
Plug the two probes into the multimeter and set the dial to 'continuity. ' If you place the red and black probes on either side of the part (some parts have diodes and are one-directional so you need to arrange the probes accordingly), and you get a read of approximately zero, electricity can flow through the part