1. ½ and ¾ rigid or can be bent by hand using a hickey bender.A hickey bender is used to bend conduit in small bends with short segments.
2. Tool Materials
3. Thin-wall metal conduit can be cut with a special electrical conduit cutter. To use the cutter, clamp it around the conduit. To cut the conduit, tighten the knurled nut in the handle
Answers & Comments
Answer:
1. ½ and ¾ rigid or can be bent by hand using a hickey bender.A hickey bender is used to bend conduit in small bends with short segments.
2. Tool Materials
3. Thin-wall metal conduit can be cut with a special electrical conduit cutter. To use the cutter, clamp it around the conduit. To cut the conduit, tighten the knurled nut in the handle
Explanation:
hope it helps :(