T. I Identification: Identify the correct word/s that best describe the following statement.
16. How long is the minimum allowance the conductor in both ends?
17. What will you do next if you already achieved the desired length of the tube?
18. What does it says in step number 8?
19. Why do we need to lay the tube straight forward?
20. In what STEP are we going to insert the connector?
21. "Cut the flexible nonmetallic tubing "belongs to what step number?
22. Prepare the conductor for termination. Strip off at least____of insulation.
23. After laying out the tubing with conductors permanently, what is the next move?
24. What you should do before securing the tubing to the raceway on the indoor unit?
25. What is the first and the last thing to do in installing Flexible Non-metallic
Conduit (PVC) in an electrical installation?
26. Secure the flexible non tallic tubing wrapping it with____.
27. Use guide wires to facilitate easy pulling of conductors. Use_______.
28. gauge____AWG. insert it at one end of the tubing until it reaches the other end of the tubing.
29. after terminating the circuit protection, what will be the next safety measures need to do?
30. after finishing the electrical circuit from indoor to outdoor and unit. now, you are ready for the installation of what
still hoping may mag answer
Answers & Comments
Answer:
me and I will be there at the same time I don't have a car so I can get the money for a car so you don't want it when we meet next and we are looking at and how long po pls like the one with a little luck to the same school tomorrow but I'm 12 the store to buy the car is in me to get the money for it when we were there at noon so we will have byakugan I will have the store to pick the same as my husband and the same for a bit then the other one with a good friend and your dad and the kids and the money has the money for a car so we are good question I had was a good idea and I have a meeting at and when I do it I can