#16 PASAGOT PO NG LAHAT NG PART NG MAAYOS AT KUMPLETO THANKS :)
PART #1
Direction: Write TRUE if the statement is correct and FALSE if it is wrong. Write your
answers on a separate sheet of paper.
_____1. Selecting the best tool for each task requires training in the proper use of the tools, field
experience in their safe use, and following the manufacturer’s guidance and
instructions for that specific tool.
_____2. When obtaining the tool, all the associated tooling and consumable parts, as
recommended by the manufacturer, must be included.
_____3. The safe use of a tool depends on using the tool for the purpose for which it was
designed and also for other purposes where it can be used as substitute where tool is
not available.
_____4. All tools should be kept in good condition with regular maintenance.
_____5. Preparing for a task includes also the sequence of tasks to be done.
Guide Questions:
1. How do you select the best tool for the job?
2. Why is it important to select the tools properly according to the task requirements?
Part #2- NASA PICTURE PO YUNG SASAGUTAN
(TASK 1: NAME A TOOL
Direction: Write the name and function of the following pictures below.)
IDENTIFICATION
Directions: Identify the appropriate tool to use for each of the following:
_1. Equalize the electrical charge between you and the equipment.
_2. Tighten / loosen screw
_3. Tighten / looses bold with a hexagonal head
_4. Retrieve parts that may be hard to reach by your fingers
_5. Tighten / loosen a slotted screw.
Answers & Comments
Answer:
I
Anti-Static Wrist Trap is used to prevent ESD damage to computer equipment
E
Anti-Static Mat is used to stand on or place hardware
D
Flat ScrewDriver is used to loosen or tighten slotted screws
F4.Philips Screw Driver is used to loosen or tighten crosshead screws
B5.Torx Screw Driver Used to tighten or loosen screws that have a star-like depression on the top
G6.Hex Driver is sometimes called a nut driver
C7.Needle-Nose Plier is used to hold small parts
H8.Wire Cutter is used to strip and cut wires
A9.Tweezers it used to manipulate small parts
J10.Flashlight is used to light up areas that you cannot see well
True1. Selecting the best tool for each task requires training in the proper use of the tools, field experience in their safe use, and following the manufacturer’s guidance and instructions for that specific tool.
True2. When obtaining the tool, all the associated tooling and consumable parts, as
recommended by the manufacturer, must be included.
True3. The safe use of a tool depends on using the tool for the purpose for which it was designed and also for other purposes where it can be used as substitute where tool is inot available.
True4. All tools should be kept in good condition with regular maintenance.
True5. Preparing for a task includes also the sequence of tasks to be done.
Guide Questions:
1. How do you select the best tool for the job?
Choose the right tools to use for work or construction and for me the best tool for me is the easy to use or you are used to using tools.
2. Why is it important to select the tools properly according to the task requirements?
Each tool is precisely designed for a specific purpose and tool will also decrease the amount of effort required to get a job and to function and effectively.
Antitastic Wrist Trap1. Equalize the electrical charge between you and the equipment.
ScrewDriver2. Tighten / loosen screw
Hex Driver3. Tighten / looses bold with a hexagonal head
Part Retriever4. Retrieve parts that may be hard to reach by your fingers
Flat-Head SrewDriver5. Tighten / loosen a slotted screw
#CarryOnLearning