Answer:

When a magnet is cut into two pieces, each piece becomes an individual magnet with a north pole and a south pole.

The magnetic field lines originate from the north pole and end at the south pole outside the magnet. Inside the magnet, the lines originate from the south pole and end at the north pole. The lines never intersect each other.

The pole strength of each piece is the same as the pole strength of the original magnet. The pieces will never get demagnetized.

To cut a magnet in half, you can:

Place the magnet on a vise to keep it in place.

Draw a clean line where you would like to cut.

Use a hacksaw to make an even cut along the line.

Explanation:

please mark as brainlist answer urgent

Verified answer

Answer:

When a magnet is cut into two pieces, each piece becomes a new magnet with its own north and south poles. The original magnet doesn't lose its magnetic properties.

Explanation:

When a magnet is cut into two pieces, each piece becomes a new magnet with its own north and south poles. This happens because the magnetic field of a magnet is not confined to a single piece, but extends throughout the entire magnet.

For example, if you have a bar magnet and you cut it in half, you will end up with two smaller magnets, each with its own north and south poles. The north pole of one piece will attract the south pole of the other piece, just like two separate magnets would.

This phenomenon occurs because the magnetic properties of a magnet are due to the alignment of its microscopic magnetic domains. When the magnet is cut, these domains remain aligned within each piece, resulting in the formation of two separate magnets.

So, cutting a magnet into two pieces doesn't cause it to lose its magnetism. Instead, it creates two smaller magnets, each with its own magnetic properties.

❣️❣️ please mark my answer as brainlist ❣️❣️