8. An instrument used to measure electrical pressure or voltage of a circuit. The unit of measure is volt (v). This is connected across or parallel to the circuit.
A. Voltmeter
B. Ammeter
C. Clamp ammeter
D. Ohmmeter

9. It is used in determining the size of wires/conductors.
A. Ruler
B. Test lights
C. Pull-push rule
D. American Wire Gauge

10. A device used to measure the voltage, resistance and current of a circuit. It is connected in parallel or series with the circuit depending on what to measure.
A. Ammeter
B. Voltmeter
C. Ohmmeter
D. Multi-tester

11. To measure the current of a circuit. What will you do?
A. Connect the test probe in parallel to the circuit
B. Connect the test probe in series to the circuit.
C. Both A and B are correct
D. None of the above

12. What is number 1 rule in measuring voltage?
A. Place the knob selector range to the lowest range of the voltage,
B. Place the knob selector range to the highest range of the voltage
C. Place the knob selector range to exact value of the Aan
D. None of the above

13. Multi- Testes is used to?
A. Measure Voltage
B. Measure Current
C. Measure Resistance
D. All of the above

14. It is a needle pike inside the meter/scale of a multi tester and it also indicate the measurement.
A. Zero ohm adjusting knob
B. Pointer
C. Adjustment Screw
D. Test Probe

15. It is used to select different functions and range of the meter.
A. Zero ohm adjusting knob
B. Range selector knob
C. Adjustment Screw
D. Test Probe​