Step:2– Pull presser foot lever up (which is generally opposite to presser foot (on the back).
Step:3– Place the fabric below the presser foot where you want to start stitching from. Pull presser foot lever down so that the fabric is ready to be sewn.
Step:4– The metal plate has the guidelines given on it for straight stitch. Make sure you hold the fabric in line with the lines given on a metal plate.
Step:5– Once everything is ready, press the pedal and the machine will start making stitches and move the fabric backward. Adjust the stitch’s speed based on how fast/slow you want to stitch.
Step:6– When you reach the endpoint and have to take a 90-degree turn, make sure the machine is stopped with the needle down (inside the fabric).
Then pull the presser feet lever up, rotate the fabric 90-degrees and push the lever down. Start stitching straight again until you finish the end of the fabric.
Answers & Comments
Answer:
Needle Bar
Bobbin case (Shuttle)
Metal Needle Plate
Presser Foot
Thread feed
Stitch length controller
Explanation:
Step:1– Pickup the fabric you want to stitch.
Step:2– Pull presser foot lever up (which is generally opposite to presser foot (on the back).
Step:3– Place the fabric below the presser foot where you want to start stitching from. Pull presser foot lever down so that the fabric is ready to be sewn.
Step:4– The metal plate has the guidelines given on it for straight stitch. Make sure you hold the fabric in line with the lines given on a metal plate.
Step:5– Once everything is ready, press the pedal and the machine will start making stitches and move the fabric backward. Adjust the stitch’s speed based on how fast/slow you want to stitch.
Step:6– When you reach the endpoint and have to take a 90-degree turn, make sure the machine is stopped with the needle down (inside the fabric).
Then pull the presser feet lever up, rotate the fabric 90-degrees and push the lever down. Start stitching straight again until you finish the end of the fabric.
That’s all!
hope it helps!
pa brainliest