Answer:
(Hot-iron Transfer)
1.place design on the fabric,then pin at the corner
2.remove excess paper around the design
3.lift the iron then move it to another area of the design
4.Set flat iron at low setting before pressing it over an area of the design for a few seconds.
(Tracing method)
1.Insert the carbon paper or dressmaker's carbon, carbon side down between the design and fabric.
2.Go over the lines of the design using a tracing wheel,a pencil or any sharp or pointed instrument to trace the design
3.place your design right side up on your fabric then pin at the corner.
hope it help
paki sagot din kailangan ko din plsss
Copyright © 2024 EHUB.TIPS team's - All rights reserved.
Answers & Comments
Answer:
(Hot-iron Transfer)
1.place design on the fabric,then pin at the corner
2.remove excess paper around the design
3.lift the iron then move it to another area of the design
4.Set flat iron at low setting before pressing it over an area of the design for a few seconds.
(Tracing method)
1.Insert the carbon paper or dressmaker's carbon, carbon side down between the design and fabric.
2.Go over the lines of the design using a tracing wheel,a pencil or any sharp or pointed instrument to trace the design
3.place your design right side up on your fabric then pin at the corner.
hope it help
paki sagot din kailangan ko din plsss