3. When reading decimal numbers, read the entire number section normally, then use "and" to symbolize the decimal point, then finish with the last-place value. You do not use the word "and" if there are no whole numbers in front of the decimal value.
4. When rounding a decimal value, there are several guidelines to follow. Simply put, if the last digit is less than 5, the previous digit is rounded down. If it's 5 or more, though, you should round up the preceding figure. So, if you're going to round a number and it's followed by 5, 6, 7, 8, 9, round it up.
Answers & Comments
Answer:
1.) Decimal Point
2.)
a) Tenths
b) Hundredths
c) Thousandths
d) Ten Thousandths
3.) Ex. Two and One-hundred forty-three Ten Thousandths ( 2.0143 )
4.) ( Ex. on the picture )
Note:
Correct me if i'm wrong
Hope it helps!<3
Goodluck!
Answer:
1. Decimal
2.
a) Tenths
b) Hundredths
c) Thousandths
d) Ten thousandths
3. When reading decimal numbers, read the entire number section normally, then use "and" to symbolize the decimal point, then finish with the last-place value. You do not use the word "and" if there are no whole numbers in front of the decimal value.
4. When rounding a decimal value, there are several guidelines to follow. Simply put, if the last digit is less than 5, the previous digit is rounded down. If it's 5 or more, though, you should round up the preceding figure. So, if you're going to round a number and it's followed by 5, 6, 7, 8, 9, round it up.
Step-by-step explanation:
Hope this helps.