PA ANSWER PO NEED KO LANG PO PLSSSS

Choose the letter of the best answer. Write the chosen letter on the space provided.
TVE TECHNICAL DRAWING 8
1. Which of the following is used to strengthen the lips of sheet metal objects and it's made
in standard sizes, 4.0mm, 6.0mm, and 10.0mm?
a. hem
b. wired edge
2. What particular type of sectional view that shows the entire cut surface of the view?
d. single hem
a. full section b. half section
c. broken-out section
d. revolved section
3. Which important feature of sectional views that shows where an object is imagined cut to
obtain a sectional view?
a. section line b. cutting plane line c. assembly section
d. removed section
4. Which of the following type of view that is applied to a circular object?
full section b. half section
c. broken-out section
d. revolved section
5. What section is used to increase the clarity and readability of assembly drawings?
a. section line b. cutting plane line c. assembly section
d. removed section
6. What gives an extra strength and rigidity to sheet metal edges?
a. hem
b. wired edge
C. seams
d. single hem
7. Which of the following is used to join bottom to vertical bodies of various shape?
a. lap seam b.grooved seam c. single seam
d. seam
8. Which shows the zigzag direction of the cutting plane if the principal interior features of
an object are not located in a straight line?
a. hem
b. offset section
c. seams
9. It is a resulting view when the cutting plane is imagined at half way across the object?
d. revolved section
a. full section b. half section
c. broken-out section
10. What do you call a fine line used to show the part of the object that was cut?
d. removed section
a. section line b. cutting plane line c. assembly section
d. single hem​