MULTIPLE CHOICE: Choose the letter of your best answer to the question. Encircle the letter of the correct answer.

1. Implements manipulated by the hand to facilitate carpentry works.
a. Tools b. Equipment c. Materials d. Hardware
2. What is a tool often kept on a carpenter's tool belt? It is used to take and make measurements.
a. Meter Stick b. Ruler c. Caliper d. Pull-push rule
3. It is a thin cross laminated sheet of wood
a. Softwood b. Lumber c. Plywood d. Hardwood
4. Why is it important to use the correct adhesives on the materials they were intended for?
a. Ensures a proper bond and no negative chemical reactions
b. Ensure the colors match correctly
c. Ensure the product does not off gas
d.  Ensures the person installing it does not get harmed
5. How do you describe a gravel
a. fine and gritty materials
b. a powdered substance
c. coarse aggregate
d. sandy materials
6. Which of the following is used for driving and pulling out nails
a. Claw Hammer b. Crowbar c. Sledge hammer d. Hammerhead
7. This is an act of requiring something to be furnished; a written request for something authorized but not made available    automatically.
a. Quantity b. Requisition c. Description d. Bill of Materials
8. When making a request for the materials and tools needed in your bulletin board project, a representative will come to approve your request. What is the name of the representative?
a. Requisitioner b. Shop Teacher c. Supply officer d. Inspector
9. All are safety precautionary measures in handling newly acquired tools and materials, EXCEPT:
a. avoid dropping the tools on the floor
b. do not expose tools and materials to sunlight
c. expose tools and materials to rain
d. Clean after use
10. Why is it important to inspect and check materials and tools for defects and damage before receiving them?
a. so that you can sell the item
b. so that you can ask for payment
c. So that you ask for a replacement
d. so that you can keep the item
11. If you are requesting a standard sheet of plywood or sheet material, how big is it?
a. 4x6 b. 4x8 c. 5x10 d. 5x5
12. How much would a 1 liter of stain maple cost at Php 140 per liter if you buy 3 liters?
a. Php 400 b. Php 420 c. Php 430 d. Php 440
13. This is setting aside materials and tools from the others
a. Segregate b. Separate c. Aggregate d. Integrate
14. It is the accounting of tools and materials available in the shop room.
a. Inventory b. Gallery c. Display d. Shopping
15. What is used as guideline in repairing defective tools?
a. Manual of Regulation
b. Book Manual
c. Repair Manual
d. User Guide​