1.Long nose pliers-used in tight spaces and for manipulating small objects, especially for bending and cutting electrical wires; needlenose pliers.
2.side cutting pliers-are pliers intended for the cutting of wire. The plane defined by the cutting edges of the jaws intersects the joint rivet at an angle or "on a
3.flat head screws-A flat-head screwdriver is a screwdriver with a wedge-shaped flat tip, used to tighten or loosen screws that have a straight, linear notch in their heads. This is arguably the most common tool on the planet—the ubiquitous flat-head screwdriver. Every junk drawer has one or two on it.
4.philips screw driver-A Phillips screwdriver has a head with pointed edges in the shape of a cross, which fit neatly into the cross slots of a Phillips screw. ... Phillips screw heads allow a tighter fit than a flat head screw, which is why most factories and handymen use them.
5.Ball peen Hammer-a hammer with a rounded end opposite the face.
Answers & Comments
Explanation:
1.Long nose pliers-used in tight spaces and for manipulating small objects, especially for bending and cutting electrical wires; needlenose pliers.
2.side cutting pliers-are pliers intended for the cutting of wire. The plane defined by the cutting edges of the jaws intersects the joint rivet at an angle or "on a
3.flat head screws-A flat-head screwdriver is a screwdriver with a wedge-shaped flat tip, used to tighten or loosen screws that have a straight, linear notch in their heads. This is arguably the most common tool on the planet—the ubiquitous flat-head screwdriver. Every junk drawer has one or two on it.
4.philips screw driver-A Phillips screwdriver has a head with pointed edges in the shape of a cross, which fit neatly into the cross slots of a Phillips screw. ... Phillips screw heads allow a tighter fit than a flat head screw, which is why most factories and handymen use them.
5.Ball peen Hammer-a hammer with a rounded end opposite the face.
hope it helps po