Title: Electricity Flow Materials: small flashlight aluminum foil comb toothpick paper clip battery self-adhesive tape coin paper Procedures: 1. Cut a part of the aluminum foil into three strips about 10cm long. 2. Fold or roll the strips until its diameter is like an electric cord. Experiment No.2 Conductors of Heat and Electricity 3. Tape one end of the first strip to the negative side of the battery. 4. Place the other end of the second strip around the light bulb. 5. Tape one end of the second strip to the positive side of the battery and the third strip together. 6. Test your connection by bringing the free ends of the second and third strips together. Adjust as necessary. 7. Once your circuit works, try testing the objects listed above, if the bulb will light up by making one side of the object touch the free end of the second strip and the other side, the free end of the third strip. 8. Be sure to disconnect the circuit between each trial for a few seconds, especially if either the aluminum foil or battery begins to heat up. 9. Record your observation below: Objects/ Materials coin toothpick paperclip paper comb coin Was the bulb lighted using these objects YES Was the bulb lighted using these objects NO,paki sagutan nalang po thankyouu po (100 points)​