Learning Task 5 Directions: Read the statement carefully and write the letter of the correct answer on the blanks before each number. 1. A pictorial drawing showing the three surfaces of the object tilted 30 degrees right and left axes in the front of the observer with equal measure is called: A. Trimetric B. Dimetric C. Isometric D. Oblique 2. This is the type of oblique pictorial view where the dimension of the receding features of the object is drawn half-scale. A. Cabinet Projection B. Cavalier Projection C. Isometric Projection D. Orthographic Projection 3. Which of the following perspective drawing has two vanishing points A. Parallel Perspective B. Oblique Perspective C. Angular Perspective D. Geometrical Perspective 4. Which of the following pictorial view is the most pleasing and has realistic effects A. Orthographic Projection C. Isometric Projection C. Oblique Drawing D. Perspective Drawing 5. Which of the pictorial drawing where one surface of an object is parallel to the frontal plane and the other is inclined to its A. Axonometric drawing B. Oblique drawing C. Orthographic drawing 0. Perspective drawing 6. Which of the following is NOT an axonometric type of pictorial drawing A. Isometric B. Dimetric C. Trimetric D. Oblique 7. If object is placed on the horizon at the eye-level of the observer it is considered as: A. Bird's eyo view B. Worm's eye view C. Man's-eye view D. Orthographic view 8. A drawing that shows a front view in its true relations and dimensions just as it would be in working drawing. It is a multi- view straight drawing wherein the size of this drawing is generally equal to the size of the axonometric drawing. A. Axonometric drawing B. Oblique drawing C. Orthographic drawing D. Perspective drawing 9. The grade 8 class were having a task sheet about interpreting the orthographic views of a mechanical object. Which among the views are considered as the regular views of an objecte A. Top, Front and Right Side View B. Top, Front and Bottom View C. Top, Front and Left Side View D. Top, Front and Rear View 10. ISO standard of engineering system state that the projection of the front view is directly below the top view. It means: A. The object is place on the third angle projection or in third quadrant. The 3 regular views are parallel and perpendicular to each other, C. The overall dimensions of the parallel views in orthographic projection are not the same. D. Non-Axonometric views appear bigger in orthographic projection

need ko na po​