LEARNING ACTIVITY 5 Direction. Read the questions carefully. Choose the best answer and write it in 1 whole sheet of paper. 1. Which of the following is NOT true? A. Always issue or lend tools with a receipt B. Drill tools should be sharpened properly. C. Keep all tools in the tool room. D. Overheat the electric soldering copper 2. When we should clean the tools? A. after using it B. free time C. once a month D. thrice a month 3. Commonly used tools and equipment should be placed at the A. center shelves B. lower shelves c. stock room D. upper shelves 4. Which is NOT an example of drilling equipment? A. auger brace B. hand drill C. phillip D. power drill 5. What are the tools under the measuring tools? A. chisel and saw B. metric rule and wire gauge C. phillip and standard D. wrench and long nose pliers 6. Tools borrowed should be returned ? A. a month after B. defective C. in good condition D. when the owner ask for it 7. Which of the following is NOT true? A. Defective tools shall be kept in section intended for them for inventory purposes B. Heavy tools and equipment should be place at the lowest shelf. C. Light tools should be placed at the upper shelf. D. Tools and equipment must be stored according to their uses 8. Which of the following classification of tools is used in bending a conduit? A. bending tools B. drilling equipment C. grinding equipment D. soldering equipment 9. Which is NOT an example of soldering equipment? A. blow torch B. power drill C. soldering gun D. soldering iron 10. Which of the following classification of tools is used in skinning wires? A. cutting tool B. drilling equipment C. driving tool D. soldering equipment​