1. A.MULTIPLE CHOICE DIRECTIONS: Choose the letter of the correct answer. Write your answers before each number 1. When tools or drawing instruments worn naturally as it reached its maximum used? A damage C natural tear and wear B.improper use D overuse of tools 2 Wrong habits or attitudes in the use of hand tools A damage C natural tear and wear B.improper use D overuse of tools 3. Maintaining effective use of drafting tools in the production of quality output A damage C improper use B good workmanship D natural tear and wear 4.Too much used and or too much imposition of force A damage C natural tear and wear Bimproper use D overuse of tools 5. Pulling too much force, the steel tape of a pull-push rule will result in A damage C natural tear and wear B improper use D overuse of tools 6 Preferably hung by inserting the hole to a nail at the end of its blade A Compass B Protractor C. Pencil DT Square 7 Basic Rules in Maintaining Hand Tools A All of the mention below B. Keep all tools in good working condition C Use the tools only for what it is designed to do D Examine/inspect the tools before each use and replace damaged tools 8. Always point the lead away from the blade of T-square to keep the loose graphite from falling on clean surfaces A Pencil B Ruler C Scale D. Triangle 9. How can we avoid malfunction of tools for effective performance? A by being irresponsible B by preventive maintenance C by leaving the tools unattended D by not checking the tools regularly 10. Before use wipe the tools and equipment with a clean A Cloth C. Oil D Wet tissue B Liquid soap​