_____1. In cutting patterns, which line should be cut? a. Dart line b. neckline c. pressing line d. seam allowance
____ 2. The armhole of the front blouse pattern is usually; a. Deeper than the back b. Longer than the back c. Shallow than the back d. Shorter than the back ____ 3. How is pressing line symbol placed in the block/final pattern? a. Along the lengthwise grain c. 45 degree on the pattern b. On the crosswise d. both crosswise and lengthwise
____ 4. Which pattern symbol is used to indicate center lines, end of seam lines, and cut with the tip of the scissors? a. Bias grain b. Crosswise grain c. dart d. lengthwise grain
____ 5. Which part of the sleeve is set to the armhole of a ladies’ blouse? a. Armscye b. hem c. sides d. any of the above
____ 7. Which of the following is not a part of a blouse? a. collar b. cuff c. placket d. belt carrier
____ 8. Different collars can be applied on ladies’ blouse except, a. Chinese collar b. continuous collar c. convertible collar d. notched collar
____ 9. When a tape measure is placed across the shoulder tip points, the item measured is a. chest b. crotch c. shoulder d. waist
____ 10. Which tool is best in shaping slight curves of the pattern? a. French curve b. hip curve c. L-square d. triangle​