Explanation:

Loosen the screws fixing the rear case and remove it.

Check and see whether or not indications of respective ranges are normal.

pull the fuse out of holder on the circuit board and replace it.

put back the rear case where it was and tighten the screws.

Follow these easy steps to fix a blown fuse:

Answer:

1. Unplug electrical appliances

First and foremost, it’s important to identify where the outage occurred. This will help you better identify which fuse is the culprit. A good way to test is to flip the light switches in each room to see which lost power. Then, keep the lights turned off in the affected areas and unplug some of the appliances in those rooms. If you leave everything on and then restore power with a new fuse, you run the risk of blowing it out or tripping the electrical panel all over again, explains Angie's List.

2. Turn the power off

Next, you will need to turn off the main power to the fuse box. This is usually done through your electrical panel and is important for staying safe.

Learn More About Home Repair Plans Near You

3. Find the fuse box

Finding a fuse box sounds simple, but many people (myself included) may not realize where it is until a situation like this arises. House Method notes that older homes will typically have a fuse box, while those built after 1965 or are remodeled with updated electrical wiring will have a circuit breaker box. Both serve the same purpose and can usually be found in the garage, basement or utility room.

Electric eLocal Banner 2

4. Identify the broken fuse

Then, you will need to determine which fuse has blown. These devices are made up of wire that can melt and break an electrical circuit when the current exceeds a safe level. They act as a safety device to prevent an electrical fire. As such, look for a fuse where the metal has melted or the glass covering appears foggy or discolored - that’s usually the broken unit.

5. Replace the fuse

When it’s time to replace the fuse, it’s important to find one that has the same amperage rating. The easiest way to do this is to take the old fuse to your local hardware store and ask for an exact replacement. Then, it’s as easy as unscrewing the broken fuse and screwing the new one into the socket.

6. Test your new setup

Once everything is squared away in the fuse box, turn the main power back on and make sure the circuit is working. Turn on lights and begin plugging in essential appliances, with care not to overload the circuit that was the problem. If the fuse blows again, it might be time to look into calling a professional electrician.

Explanation:

semsya yan lang po alm ko hehe pa brainlies po