Answer:
STEPS:
1. Using your straightedge, draw a reference line, if one is not provided.
2. Copy the side of the square onto the reference line, starting at a point labeled A'.
3. Construct a perpendicular at point B' to the line through ab2.
4. Place your compass point at B', and copy the side of the square onto the perpendicular b'g. Label the end of the segment copy as point C.
5. With your compass still set at a span representing AB, place the compass point at C and swing an arc to the left.
6. Holding this same span, place the compass point at A' and swing an arc intersecting with the previous arc. Label the point of intersection as D.
7. Connect points A' to D, D to C, and C to B' to form a square.
Step-by-step explanation:
METHOD 2: STEPS:
1. Using your compass, draw a circle and label the center O.
2. Using your straightedge, draw a diameter of the circle, labeling the endpoints A and B.
3. Construct the perpendicular bisector of the diameter, ab2.
4. Label the points where the bisector intersects the circle as C and D.
5. Connect points A to B to C to D to form the square.
Copyright © 2024 EHUB.TIPS team's - All rights reserved.
Answers & Comments
Answer:
STEPS:
1. Using your straightedge, draw a reference line, if one is not provided.
2. Copy the side of the square onto the reference line, starting at a point labeled A'.
3. Construct a perpendicular at point B' to the line through ab2.
4. Place your compass point at B', and copy the side of the square onto the perpendicular b'g. Label the end of the segment copy as point C.
5. With your compass still set at a span representing AB, place the compass point at C and swing an arc to the left.
6. Holding this same span, place the compass point at A' and swing an arc intersecting with the previous arc. Label the point of intersection as D.
7. Connect points A' to D, D to C, and C to B' to form a square.
Step-by-step explanation:
METHOD 2: STEPS:
1. Using your compass, draw a circle and label the center O.
2. Using your straightedge, draw a diameter of the circle, labeling the endpoints A and B.
3. Construct the perpendicular bisector of the diameter, ab2.
4. Label the points where the bisector intersects the circle as C and D.
5. Connect points A to B to C to D to form the square.