Start by drawing a horizontal line segment of any length and label its endpoints as F and T.
Use a protractor to draw a diagonal line segment from F to T.
Construct a Rhombus:
With the endpoints F and T established, take FS = 10 cm and AT = 8 cm.
Using a ruler and a protractor, construct a rhombus by making sure that the sides are of the given lengths. Since a rhombus has all sides equal, the lengths of the sides should be consistent with the given diagonals.
Complete the Rhombus:
Once you have constructed two adjacent sides of the rhombus, draw the remaining two sides. The opposite sides of a rhombus are parallel and equal in length.
Check for Rhombus Properties:
Make sure that opposite sides are parallel and equal in length.
Confirm that the diagonals bisect each other at right angles. If needed, use a protractor to check the angles formed at the intersection of the diagonals (F and T).
Remember that constructing accurate geometric figures requires precision with a ruler, protractor, and compass. If you encounter any difficulties, double-check your measurements and angles to ensure accuracy.
Answers & Comments
Answer:
Step-by-step explanation:
To construct a rhombus with given diagonals
�
�
=
10
cm
FS=10 cm and
�
�
=
8
cm
AT=8 cm, follow these steps:
Draw the Diagonals:
Start by drawing a horizontal line segment of any length and label its endpoints as F and T.
Use a protractor to draw a diagonal line segment from F to T.
Construct a Rhombus:
With the endpoints F and T established, take FS = 10 cm and AT = 8 cm.
Using a ruler and a protractor, construct a rhombus by making sure that the sides are of the given lengths. Since a rhombus has all sides equal, the lengths of the sides should be consistent with the given diagonals.
Complete the Rhombus:
Once you have constructed two adjacent sides of the rhombus, draw the remaining two sides. The opposite sides of a rhombus are parallel and equal in length.
Check for Rhombus Properties:
Make sure that opposite sides are parallel and equal in length.
Confirm that the diagonals bisect each other at right angles. If needed, use a protractor to check the angles formed at the intersection of the diagonals (F and T).
Remember that constructing accurate geometric figures requires precision with a ruler, protractor, and compass. If you encounter any difficulties, double-check your measurements and angles to ensure accuracy.
Verified answer
Answer: Step1: Draw a line of 10 cm FS
Step2: with the help of compass take a distance more than half and bisect it at T and A
Step3: now meet T and A
step4: through centre cut this of 4 cm in upper and lower for make 8 cm
Now meet T and F,T and S , F and A, S and A
Step-by-step explanation: mark me as Brainliest if it was helpful, also make sure to follow!!