8. By using a
section of a ovlindrical mechanical part the Technical drawing
student shonld be able to show only a view of lhe part
A. half
B. whole
C. revolved
D broken out
9. In the section vicu, the seas that would have been in actual contact with the cutting plannen
are shown with
A. A cutting planse line
B. Section lining
C. Visible lines
D. Lines and arrows
10. These breaks are used to shorten the view of an object:
A. Section breaks
B. Aligned breaks
C. Conventional breaks
D. Full breaks
11. In most building, frawings
are often used to illustrate and detast structura)
components.
A. Foundation ben detail sections
B. Wall sections
C. Building sections
D. All of the above
12. When only a small section of an interior are needs to be revealed the Tech drawing
studeni can use a
section
A half
B. quarter
C. full
D. brokes out
13. Ia dua type of section, one warter of Oddbject is to:
A. Revolved section
B. Rentaved section
C. Quarter section
D. Half section
14. A
section allows the Technical drawing student to create a Cutting Planc lino
which is not in 2 straight line garance the pert
A. Offset
B. Half
c. Whole
D. Broken out
15. The
is a standard element of a section view in a technical drawing.
A. Cutting Plane line
B. Section lines
C. Material haich pattern
D. All of the above
16. If a designer is developing a plan for a project in which the entire part is made out of
10mm sziok plywood and he only wants to use one view, he should use the
view.
A front
B.top
C. night
D. back