Not What I know? A. Match the given electrical tocs and measuring instruments with their respective functions. ad a) Phillips screw driver b) Standard screwdriver c) Long nose plier d) Lineman's plier e) Wire stripper 1) Electrician's knife g) Wire gauge h) Key hole saw 1) Heet gun 3) Pipe cutter k) Pipe burring reamer 1) Portable electric drill m) Soldering iron a) Multi-tester o) Clamp meter 1. The blade tip is cross or positive fit with positive or cross slot head screws. 2. Used in sizing conductors; can measure from gauge no. O to gauge no. 36 3. Used to cut away edges or burrs inside the end of the pipe after it has been cut with pipe cutter 4. It is used to measure current flowing in a conductor. It is connected to or clamped on the conductor. 5. A small drilling rachine with a chuck capacity of % and 3/8" and used to bore holes on lighter metal work 6. The blade tip is formed flat fit to slotted flat head screw. 7 Used for cutting and holding fine wires; can reach into tight spaces; commonly used by electricians to make terminal loops in copper wire 8. A thin blade saw used to cut rectangular or square holes in walls for installation of flus)-mounted convenience outlet 9. A hand tool most commonly used in soldering. It supplies heat to melt the solder so hat it can flow into the joint between two work pieces. 10. It is used to bend PVC pipes of non-metallic conduit. 11. Used for cutting medium or fine wires and for bending small pieces of soft metals 12. An electrical tool that is used to remove insulation of medium sized wires. 13. Used by linemen to remove insulation of cables in high or low voltage transmission line 14. Also called as VOM, it is used to measure the voltage, resistance or current in a circuit 15. Used to cut small sizes of metal conduits. 39 pasagot ako plsss
nonsense=report
nonsense=report
Add an Answer
More Questions From This User See All