46. Which is NOT true in a parallel connection? *
a. Loads form branches.
b. The voltage is the same across each load.
c. It provides a separate path for charges to flow.
d. When one bulb is removed in any branch it affects the other branch.
For item number 47 refer to the illustration below. 47. What electrical appliances have the highest energy consumption? What electrical appliances have the highest power rating? *
a. Iron no. 1
b. Iron no.2
c. Kettle no. 1
d. Kettle no. 2
48. “I left a 60W light bulb on for 30 days, which raised my electric bill by 43.2 kWh (kilowatt-hours).” This statement is an example of *
a. Electrical energy
b.Electrical generation
c.Electrical Power
d.Electrical voltage
49. What does the picture below represent as an electrical safety device in our homes? *
a. circuit breakers
b.double insulation
c. earthing (grounding)
d.fuses
50. It occurs when the exposed parts of the electrical wires touch one another. *
a.Closed circuit
b.Open circuit
c.Overload circuit
d.short circuit
help po summative po wag sasagot kung hindi alam ang sagot!
Answers & Comments
Answer:
46.a
In a parallel circuit, each device is placed in its own separate branch. The presence of branch lines means that there are multiple pathways by which charge can traverse the external circuit. Each charge passing through the loop of the external circuit will pass through a single resistor present in a single branch.
47.D kettle no.2
The most popular use for a kettle, whether it is stovetop or electric, is to make hot beverages. To make tea or coffee, all you really need to do is add water to your kettle and let it heat to the appropriate temperature
48.D electrical voltage
Let's say you have a 60-watt incandescent lightbulb and you are paying 12 cents per kWh of energy. Leaving the bulb on the whole day will therefore cost you: 0.06 (60 watts / 1000) kilowatts x 24 hours x 12 cents = approximately 20 cents in one day.
49.A cerecuit breakers
A circuit breaker is an electrical switch designed to protect an electrical circuit from damage caused by overcurrent/overload or short circuit. Its basic function is to interrupt current flow after protective relays detect a fault.
50.B open cercuit
You will receive a shock if you touch two wires at different voltages at the same time. You will receive a shock if you touch a live wire and are grounded at the same time. When a circuit, electrical component, or equipment is energized, a potential shock hazard is present.
Explanation:
Sorry tagal
1 point
Hot
Normal
Cold
Freezing point
This is a required question
24. Why does sound travel faster at night than day? *
1 point
The sound wave travels slower due to no sunlight.
The sound wave travels faster due to the warmth of the sun.
The sound waves travel and refract from the warmer region towards the cooler region.
The sound waves travel and refract from the cooler region towards the warmer region.
1 point
Echo
refraction
reflection
Reverberation