15. They are usually made vertical and oblique lines. A. triangle of celluloid or B. T-square C.Triangular scole plastic and come in various C.Triangular scale D. French curve size used for drawing D. French curve 16. Which of the following statement is NOT a step in positioning a drawing paper on A. Position the 1-square against the working edge and press firmly the body. B. Use masking tape to fasten at least two opposite comers or four corners to make the drawing table? drawing paper stable. C. Place the edge of the drawing paper parallel or aligned on the edge of the working blade and of the T-square. D. Gradually side the head of the T-square against the working edge of the drawing table. 17. How do you properly clean and keep a T-square after using it? A. Remove the head. Soak the head of the T-square to a warm and soapy water. B. Using wet tissue clean the inner space of the T-square. C. Use rug to clean the body of the T-square, brush with 1/2-inch paintbrush the inner space where the head and the body of the T-square is connected. D. Soak the T-square in a warm soapy water. Hang it until it dries. 18. this department is in-charge of unloading, unpacking of incoming materials, checks. Identify goods, received with descriptions on the purchase order. A. Accounting department B. Receiving department C. Sales department D. Budget department 19. This form shows proof or receipt of goods and services. A. Delivery receipt form B. Inventory form C. Purchase order form D. Requisition slip form 20. This form contains specified quantities of described goods at agreed terms and at a designated time and place. A. Delivery receipt form) 8. Inventory form C. Purchase order form D. Requisition slip form 21. This form is a printed document on which a request is made. A. Delivery receipt form B. Inventory form C. Purchase order form D. Requisition slip form 22. This form contains information about the name, purchase information and cost of goods and displays on a balance sheet. A. Delivery receipt form C. Purchase order form D. Requisition slip form B. Inventory form 23. Which of the following is NOT true about measurement? A. Measurement is vital for all parts of manufacturing and production technology. B. Measurement must be consistent so that people have a common understanding. C. Measurement must be based on guidelines set by the industry.. D. Measurement requires advance skills. 24. What is the basic unit of measurement in the Systems International measurement? A. Centimeter B. Decimeter C. Meter 25. What tool is best used to measure the length of a notebook? a. foot ruleB. Triangle c. meter stuch D. Kilometer the efons: Using the que D. T - square​