Part III. USING FLOWCHART
Directions: Choose the correct answer inside the box that best describes the given statement below. Write your answer on the space provided.
Connecting Lines Dashed Lined Interrupted Lines
1. _______________________It is where when are drawn parallel to each other, the space between them should be at least 1/16 inch when the diagram is reduced to final size.
2. _______________________It shows a mechanical linkage between components or parts of components.
3. _______________________No more than three lines should be drawn to any point on a circuit diagram.
4. ____________________Other parts on a diagram should, whenever possible, be drawn either horizontally or vertically.
5. _____________________This is use on schematic and other types of diagrams
6. _____________________This is when a diagram does not provide for a continuation of these lines to their final destination.
7.____________________This line can be located as close as possible to the point of interruption.
8. ______________________This line identification can also indicate the destination.
9. _______________________This line is usually given in conjunction with brackets.
10. _______________________This procedure reduces the possibility of line crowding that could make the interpretation of a diagram more difficult than necessary.
Directions: Choose the correct answer inside the box that best describes the given statement below. Write your answer on the space provided.
Connecting Lines Dashed Lined Interrupted Lines
1. _______________________It is where when are drawn parallel to each other, the space between them should be at least 1/16 inch when the diagram is reduced to final size.
2. _______________________It shows a mechanical linkage between components or parts of components.
3. _______________________No more than three lines should be drawn to any point on a circuit diagram.
4. ____________________Other parts on a diagram should, whenever possible, be drawn either horizontally or vertically.
5. _____________________This is use on schematic and other types of diagrams
6. _____________________This is when a diagram does not provide for a continuation of these lines to their final destination.
7.____________________This line can be located as close as possible to the point of interruption.
8. ______________________This line identification can also indicate the destination.
9. _______________________This line is usually given in conjunction with brackets.
10. _______________________This procedure reduces the possibility of line crowding that could make the interpretation of a diagram more difficult than necessary.
Add an Answer
More Questions From This User See All
Answers & Comments
Answer:
1.Connecting Lines
2.Interrupted Lines
3.Dashed Lines
4.Interrupted Lines
5. Connecting Lines
6. Connecting Lines
7.Connecting Lines
8.Dashed Lines
9. Interrupted Lines
10. Dashed lines