1. Multiple Choices.
Read and understand the questions below carefully, encircle the letter of the correct answer.
Please use this paper as your answer sheet. (Alayon asya ini an gamita na answeran nganhi kamo paganswer)
1. It is purposely drawn to show the inside portion of the object. The direction of the cutting plane line is a major reference
to consider in determining the form of view to be drawn. Which one is it?
a Sectional drawing
d. Sketch
c. Scale drawing
b. Orthographic drawing
2. How do you call a kind of section view that shows the entire cut surface of the view?
a Full section
b Half section
c. Revolved section
d. Removed section
3. When there is portion of the view being taken out, what kind of section view is it?
a Revolved section
b. Full section
c. Broken-out section
d. Assembly section
4. It is a type of section applied to a circular object. The resulting view is similar to full section view. What is it?
a Full section
b. Half section
C. Revolved section
d. Removed section
5. Which section view below is generally used in furniture, machine, and architectural drawing wherein the appearance of
the sectional view depends on the location of the cutting - plane lines?
a Removed section b. Assembly section
c. Revolved section
d. Full section
6. How do you call a kind of section view which shows the zigzag direction of the cutting plane if the principal interior
features of an object are not located in a straight line and is necessary to offset the cutting-plane line to allow to pass
through as many of the principal features of the object?
a Revolved section
b. Full section
c Broken-out section
d Offset section
7. This section view may be used to increase the clarity and readability of assembly drawings. Which below is it?
a Assembly section
b. Half section
c. Revolved section d. Full section
8. How do you call an imaginary line which shows where an object is imagined cut to obtain a sectional view?
a. Cutting plane line
b Section line
c. Hidden line
d. Object line
9 It is a fine line used to show the part of the object being cut inclined at 45 degrees angle Each line must have at least
2mm distance from each other. What is it?
a Section line
b. Hidden line
c. Center line
d. Removed section
10. Below are the principles of sectioning except for one, which one is it?
a it shows the type of material to be used in an actual project
b. It shows more detailed illustration particularly on the internal parts of the object.
c. It describes the shape of the internal parts
d. It is the most common type of assembly drawing



pa help po braineleist ko po mag answer with explanation
pleas help​