1. It is used for bending wires and picking small components in a confined area.
A. bent nose pliers
B. long nose pliers
C. tweezer
D. wire cutter

2. It is an invaluable tool for stringing the beads as they easily secure crimps.
A. chain-nose pliers
C. curved chain-nose pliers
B. crimping pliers
D. flush cutter

3. Which pliers are used in making a loop?

A. chain-nose pliers

C. nose pliers

B. flat nose pliers

D. round nose pliers


4. It is referred to as a tool for snipping or cutting wires in jewelry making.

A. cookie-cutter

B. scissors

C. wire cutter

D. wire snips

5. Type of pliers that can cut and hold small jewelry components.


A. bent nose pliers

C. snipe nose pliers

B. flush cutter

D. round nose pliers

6. How will you describe the crimps made by crimping pliers?

A. Its surface is flat and tightly made.

B. It is round, done neatly and tightly.

C. The surface becomes elongated and loose.

D. It is flat on the sides and elongated from top to bottom.


7. How to start crimping with the use of crimping pliers?

A. Place the crimp bead into the U-shaped notch of the tool.

B. Place the crimp bead into the O-shaped notch of the crimp tool.

C. Place crimp bead into the threader, then make a loop and twist the end.

D. Place crimp bead into the threader, then loop it through a clasp and then

thread the end.


8. What follows after placing the crimp in the outer jaw or the O shape hole of the

crimping pliers?

A. Flattened the crimp.

B. Add another crimp.

C. Squeeze the crimp firmly.

D. Make one hard compression.

9. Which one is true in bending wires with nose pliers?


A. Bend wire towards you.

B. Bend wire away from you.

C. Keep the end of the wire farther from you.

D. Bend the wire end first before the actual bends.


10. What will you do with the sharp end of the wire after bending or twisting it?

A. Cut the end with a flush cutter.

B. Smoothened the end with fine sandpaper.

C. Push down the sharp end of the wire with chain-nose pliers.

D. Cut and remove the sharp edge of the wire using a metal file.
​